I recenetly purchased my first drone (SG906), and I stupidly crashed it on my first flight outdoors cos it was too windy and I didn't find out about excessive velocity mode. There was some vital injury to the gimbal, it was hanging off by the wires. It nonetheless works and maintains a gentle place, however I don't know find out how to put it again in place or wether it used screws or simply glue. I do know it needs to be kind of floating on the rubber nubs however I don't know methods to fasten it in place. Like ought to I exploit tremendous glue? Or did it have screws and I misplaced them within the crash?
Different injury to the drone is the underside left hinge is a bit slack and has misplaced the cap cowl for it. It typically strikes place mid flight inflicting the stability to be off. Additionally the drone retains altering altitude mechanically. It gained't keep in a single place, it both lowers or lifts a meter or so above the meant peak.
Would anybody know the best way to type this out as I'm at a loss a bit. Thanks.